VERTICLE EPOXY ACID SHIELD AG15-200

VERTICLE EPOXY ACID SHIELD AG15-200

$299.00
COLOR::  SIZE:: 
Quantity

EPOXY ACID SHIELD AG15-200 FOR METAL AND MASONSRY VERTICAL SUFACES

Similar to our AG253/256 this is a product system for all mechanical equipment, block walls, piping and other vertical surfaces in corrosive environments. Consists of one gallon of AG15 Primer coat and one gallon of AG200 Topcoat. 10 Gallon set consists of 5 gallons of primer and 5 gallons of topcoat. Cures to a tile like finish that is abrasion and impact resistant while protecting your physical assets from chemical and acid corrosion.

Testimonial from Monique from South Florida. "Hey Adam it's Monique just wanted to let you know that your product has held up fantastically well and it's time to redo all 125 of our doors. I've attached a picture for you to see how the doors look after 10 years of saltwater exposure. Will be sending over our PO shortly. Thanks again for a great product!" Acid Epoxy Coated Door

Not recommended for vehicular traffic, this is engineered for surfaces difficult to coat with epoxy due to the nature of thick epoxies to run down vertical surfaces.

ArmorGarage provides a 2 year warranty against product defects when properly mixed and applied to a properly prepared concrete surface. Please refer to our full warranty policy located under "SHIPPING".

Mix Part A & Part B in a 4:1 ratio until streak free. Allow mixed product to stand 30 minutes before applying to allow resins and hardners to fully interact. Apply with 3/8" nap rollers, brush or sprayer. Two coats may be required depending on surface condition. All surfaces should be prepped and free of any contaminants, loose rust or other corrosive residues.

Sign Up For Our Newsletter For the Latest News and Offers